[SOURce:]ARB:SEQuence:STEP:CURRent:SINusoid:OFFSet<value>, <step#>, (@<chanlist>)
[SOURce:]ARB:SEQuence:STEP:CURRent:SINusoid:OFFSet? [MIN|MAX,] <step#>, (@<chanlist>)
[SOURce:]ARB:SEQuence:STEP:VOLTage:SINusoid:OFFSet <value>, <step#>, (@<chanlist>)
[SOURce:]ARB:SEQuence:STEP:VOLTage:SINusoid:OFFSet? [MIN|MAX,] <step#>, (@<chanlist>)
[SOURce:]ARB:SEQuence:STEP:POWer:SINusoid:OFFSet <value>, <step#>, (@<chanlist>)
[SOURce:]ARB:SEQuence:STEP:POWer:SINusoid:OFFSet? [MIN|MAX,] <step#>, (@<chanlist>)
[SOURce:]ARB:SEQuence:STEP:RESISTANCE:SINusoid:OFFSet <value>, <step#>, (@<chanlist>)
[SOURce:]ARB:SEQuence:STEP:RESISTANCE:SINusoid:OFFSet? [MIN|MAX,] <step#>, (@<chanlist>)
Specifies the offset of the current, voltage, power, or resistance sine wave from zero for Arb sequence
steps.
Except for models N678xA SMU, the output cannot generate negative amplitudes.
Therefore, the offset value cannot be less than the peak value of the sine wave.
Parameter Typical Return
Current: 0 - maximum|MIN|MAX, *RST 0
Voltage: 0 - maximum|MIN|MAX, *RST 0
Power: 0 - maximum|MIN|MAX, *RST MIN
Resistance: 0 - maximum|MIN|MAX, *RST MIN
Values are range and module-rating dependent.
<offsetvalue>
Step 0 - 99, *RST 0 (none)
Programs a current offset: ARB:CURR:SIN:OFFS 5,(@1)
Programs a voltage offset: ARB:VOLT:SIN:OFFS 10,(@1)
Programs a power offset: ARB:POW:SIN:OFFS 30,(@1)
Programs a resistance offset: ARB:RESISTANCE:SIN:OFFS 50,(@1)
Programs a current offsetfor step 0: ARB:SEQ:STEP:CURR:SIN:OFFS 5, 0,(@1)
Keysight N6700C Operating and Service Guide 205
5 SCPI Programming Reference
To Next Page
Loading...
