Arrow keys ÇÈ
You can also use the arrow keys to adjust the value up or down and switch
between + and − limits on Models N678xA SMU. When the output is on and the
unit is operating in CC mode, the output current changes immediately. Otherwise,
the value will become effective when the output is turned on
Method 2 - Use the Current key to enter a value
Press Current to select the current entry field. In the display below, channel 1’s
current setting is selected. Enter the desired setting using the numeric keypad.
Then press Enter.
If you make a mistake, either use the Å backspace key to delete the number, press
Back to back out of the menu, or press Meter to return to meter mode.
Enable the Output
Use the On/Off key to enable the output
If a load is connected to the output, the front panel display will indicate that it is
drawing current. Otherwise, the current reading will be zero. The status indicator
next to the channel number indicates the output’s status. In this case, the output
channel is in constant voltage mode.
For a description of the status indicators, refer to Front Panel Display – At a Glance.
Use the Front Panel Menu
The front panel command menu lets you access most of the power system’s functions. The actual
function controls are located at the lowest menu level. Briefly:
l Press the Menu key to access the command menu.
l Press the left and right (t, u) navigation keys to move across the menu commands.
l Press the center Select key to select a command and move down to the next level in the menu.
3 Getting Started
82 Keysight N6700C Operating and Service Guide
To Next Page
Loading...
