Reset (*RST) and Non-Volatile Settings
Reset State
Non-Volatile Settings
Reset State (*RST)
The following tables show the reset state. These parameters are set to the indicated values at power-
on or after *RST.
The power-on/reset state may differ from that shown below if you have enabled power-
on state recall mode from the States menu (see Instrument State Storage).
CPI Command *RST Settings
ARB:COUNt 1 OUTPut:PROTect:COUPle OFF
ARB:CURRent|VOLTage:CDWell:DWELl 0.001 OUTPut:PROTect:DELay 0.02
ARB:CURRent|VOLTage:CDWell:LEVel MIN OUTPut:PROTect:OSCillation ON
ARB:CURRent|VOLTage:EXPonential:END MIN OUTPut:PROTect:WDOG OFF
ARB:CURRent|VOLTage:EXPonential:STARt MIN OUTPut:RELay:POLarity NORM
ARB:CURRent|VOLTage:EXPonential:STARt:TIMe 0 OUTPut:SHORt OFF
ARB:CURRent|VOLTage:EXPonential:TCONstant 1 OUTPut:TMODe LOWZ
ARB:CURRent|VOLTage:EXPonential:TIMe 1 POWer MIN
ARB:CURRent|VOLTage:PULSe:END:TIMe 0 POWer:LIMit MAX
ARB:CURRent|VOLTage:PULSe:STARt MIN POWer:MODE FIX
ARB:CURRent|VOLTage:PULSe:STARt:TIMe 0 POWer:PROTection:DELay 0.02
ARB:CURRent|VOLTage:PULSe:TOP MIN POWer:PROTection:STATe OFF
ARB:CURRent|VOLTage:PULSe:TOP:TIMe 1 POWer:RANGe MAX
ARB:CURRent|VOLTage:RAMP:END MIN POWer:SLEW MAX
ARB:CURRent|VOLTage:RAMP:END:TIMe 0 POWer:SLEW:COUPle ON
ARB:CURRent|VOLTage:RAMP:RTIMe 1 POWer:SLEW:MAX ON
ARB:CURRent|VOLTage:RAMP:STARt MIN POWer:SLEW:NEGative MAX
ARB:CURRent|VOLTage:RAMP:STARt:TIMe 0 POWer:SLEW:NEGative:MAX ON
Keysight N6700C Operating and Service Guide 313
5 SCPI Programming Reference
To Next Page
Loading...
