Front Panel Menu Reference SCPI Command
Select Transient\Arb\Function.
Select a Voltage, Current, Power, or Resistance Arb Type.
Then selectthe Pulse Shape. Then press Select.
To selecta current, voltage, power, or resistance pulse Arb,
use:
ARB:FUNC:TYPE VOLT|CURR|POW|RES,(@1)
ARB:FUNC:SHAP PULS,(@1)
Step 2. Configure the pulse parameters. The parameters apply to the selected Arb type (Voltage,
Current, Power, or Resistance).
Enter the values for the level before and during the top of the pulse.
Enter the time before the pulse, the time of the pulse, the time after the pulse. A pulse frequency can
only be specified directly using SCPI commands. The pulse frequency can also be specified using the
Time parameters.
Front Panel Menu Reference SCPI Command
Select Transient\Arb\Config\Pulse\Level.
Enter the Start and Top level in volts. Then press Select.
Select Transient\Arb\Config\Pulse\Time.
Enter the Start, Top, and End times in seconds. Then press
Select.
To configure a voltage pulse Arb, use:
ARB:VOLT:PULS:STAR 0,(@1)
ARB:VOLT:PULS:TOP 10,(@1)
ARB:VOLT:PULS:STAR:TIM 0.25,(@1)
ARB:VOLT:PULS:TOP:TIM 0.5,(@1)
ARB:VOLT:PULS:END:TIM 0.25,(@1)
ARB:VOLT:PULS:FREQ 1,(@1)
Step 3. Configure the final steps common to all Arbs. Refer to Configuring Steps Common to all Arbs at
the end of this section.
Configuring Ramp Arbs
Step 1. Select the Arb Type and Shape. Power and Resistance types apply to .
Front Panel Menu Reference SCPI Command
Select Transient\Arb\Function.
Select a Voltage, Current, Power, or Resistance Arb Type.
Then selectthe Ramp Shape. Then press Select.
To selecta current, voltage, power, or resistance ramp Arb,
use:
ARB:FUNC:TYPE VOLT|CURR|POW|RES,(@1)
ARB:FUNC:SHAP RAMP,(@1)
Step 2. Configure the ramp parameters. The parameters apply to the selected Arb type (Voltage,
Current, Power, or Resistance).
Keysight N6700C Operating and Service Guide 121
4 Operating the Power System
To Next Page
Loading...
