Keysight N6701C - Page 275

l The query returns the value that was sent. If the value is less than the minimum slew rate, only
the minimum value is returned. The resolution of the slew setting is also the minimum value, which
can be queried using POWer:SLEW? MIN. The exact value varies slightly based on calibration.
l The query returns the programmed slew rate in the form +n.nnnnnnE+nn for each channel spe-
cified. Multiple responses are separated by commas. If a slew rate of 9.9E37 is returned, it means
that the maximum or fastest slew rate has been set.
[SOURce:]POWer:SLEW:COUPle 0|OFF|1|ON, (@<chanlist>)
[SOURce:]POWer:SLEW:COUPle? (@<chanlist>)
Sets the input power slew tracking state.
Parameter Typical Return
0|OFF|1|ON, *RST OFF 0or1
Enables the input power slewtracking state: POW:SLEW:COUP ON, (@1)
[SOURce:]POWer:SLEW[:POSitive]:MAXimum 0|OFF|1|ON, (@<chanlist>)
[SOURce:]POWer:SLEW[:POSitive]:MAXimum? (@<chanlist>)
[SOURce:]POWer:SLEW:NEGative:MAXimum 0|OFF|1|ON, (@<chanlist>)
[SOURce:]POWer:SLEW:NEGative:MAXimum? (@<chanlist>)
Enables/disables the maximum slew rate override. When enabled, the slew rate is set to its maximum
value. When disabled, the slew rate is set to the immediate value set by POWer:SLEW. Use
POWer:SLEW? MAX to query the maximum slew rate.
Parameter Typical Return
0|OFF|1|ON, *RST OFF 0or1
Enable the maximum slewrate override: POW:SLEW:MAX ON, (@1)
Enable the negative maximum slewrate: POW:SLEW:NEG:MAX ON, (@1)
l The POWer:SLEW:MAX command is coupled to the POWer:SLEW command. If the POWer:SLEW
command sets the slew rate to MAX or INFinity, POWer:SLEW:MAX is enabled. If the slew rate is
set to any other value, POWer:SLEW:MAX is disabled.
Keysight N6700C Operating and Service Guide 275
5 SCPI Programming Reference