Keysight N6701C - Page 366

Front Panel Menu Reference SCPI Command
Select System\Admin\Cal\Curr\Imeas
Select the Low1 range. Then press Next.
CAL:CURR:MEAS 0.1, (@1)
Step 3. Select the first current calibration point and enter the data.
Front Panel Menu Reference SCPI Command
Display shows: “Enter P1 measured data” Measure the current with the Keysight
3458A and enter the data.
Press Select when done.
CAL:LEV P1
*OPC?
CAL:DATA <data>
Step 4. Select the second current calibration point for the negative range and enter the data. The
value should be negative.
Front Panel Menu Reference SCPI Command
Display shows: “Enter P2 measured data”
Measure the current with the Keysight 3458A and enter the data. Press Select
when done.
CAL:LEV P2
*OPC?
CAL:DATA <data>
1 mA Measurement Range - All Models
Step 1. Connect the Keysight 3458A in series with a 10 kΩ resistor to the output (see Equipment
Required and Cal Setup D).
Step 2. Select the 1 mA measurement range of output 1.
Front Panel Menu Reference SCPI Command
Select System\Admin\Cal\Curr\Imeas
Select the Low2 range. Then press Next.
CAL:CURR:MEAS 0.001, (@1)
Step 3. Select the first current calibration point and enter the data.
Front Panel Menu Reference SCPI Command
Display shows: “Enter P1 measured data” Measure the current with the Keysight
3458A and enter the data.
Press Select when done.
CAL:LEV P1
*OPC?
CAL:DATA <data>
Step 4 applies only to models N6781A, N6782A, and N6784A
Step 4. Select the second current calibration point for the negative range and enter the data. The
value should be negative.
Front Panel Menu Reference SCPI Command
Display shows: “Enter P2 measured data”
Measure the current with the Keysight 3458A and enter the data. Press Select
when done.
CAL:LEV P2
*OPC?
CAL:DATA <data>
6 Verification and Calibration
366 Keysight N6700C Operating and Service Guide