3 Spectrum Analyzer Mode
3.8 Spurious Emissions Measurement
:SPUR:DET2?
Notes For backward compatibility, “NORMal” is available as a SCPI command parameter. However, this is
treated same as “RMS” internally, so the query never returns “NORMal” as its results
Preset
OFF, OFF, OFF, OFF, OFF, OFF, OFF, OFF, OFF, OFF, OFF, OFF, OFF, OFF, OFF,
OFF, OFF, OFF, OFF, OFF
State Saved Saved in instrument state
Range Off | Normal | Average | Peak | Sample | Negative Peak
Limits
Lets you set Start and Stop Limits and Threshold values for each Range.
Frequency Range
Same as Frequency Range under the Bandwidth tab. See "Frequency Range" on
page 1460. This control does not appear in MSR mode.
Enabled
Same as the Enabled checkbox under the Bandwidth tab. See"Enabled" on page
1437.
Start Freq
Same as the Start Freq column under the Bandwidth tab. See"Start Freq" on page
1438. This column does not appear in MSR.
Stop Freq
Same as the Stop Freq column under the Bandwidth tab. See"Stop Freq" on page
1439. This column does not appear in MSR.
Center Frequency
Same as the Center column under the Bandwidth tab. See"Center Frequency" on
page 1455. This column does not appear in MSR mode.
Spectrum Analyzer Mode User's &Programmer's Reference 1465
To Next Page
Loading...
