Keysight N9000B - 3.12.3.17 Preselector Adjust

3 Spectrum Analyzer Mode
3.12 List Sweep Measurement (Remote Only)
Sets a list of 4 preselector center states
Preset Sets preselector center state to off
State Saved Saved in instrument state
Remote Command
[:SENSe]:LIST:PCENter:POINts?
Example
[:SENSe]:LIST:PCEN:POIN?
3.12.3.17 Preselector Adjust
This command defines a list of Preselector Adjust offset frequencies. A preselector
center state that is set to true will override a preselector adjust offset frequency.
Remote Command
[:SENSe]:LIST:PADJust <freq>[, <freq>]
[:SENSe]:LIST:PADJust?
Example
LIST:PCEN 1.0 MHz, 2.0 MHz, 3.5 MHz, 2.0 MHz
Sets a list of 4 preselector adjust offset frequencies
Preset Sets the preselector center offset frequency to zero
State Saved Saved in instrument state
Remote Command
[:SENSe]:LIST:PADJust:POINts?
Example
[:SENSe]:LIST:PADJust:POIN?
1946 Spectrum Analyzer Mode User's &Programmer's Reference