Keysight N9000B - 3.5.3 Measurement Results for n = 3; 3.5.4 Measurement Results for n = 7

3 Spectrum Analyzer Mode
3.5 ACP Measurement
3.5.3 Measurement Results for n = 3
For the trace specified by "Measure Trace" on page 1754, returns scalar pass/fail
values (0 = passed, or 1 = failed) determined by comparing the relative to the
reference carrier and by testing the absolute power limit of the offset frequencies
(measured as total power in dB if "Measurement Type" on page 1055 is Total Pwr
Ref, or as power spectral density in dB if Measurement Type is PSD Ref).
When "Max Num of Offsets" on page 1010 is 6, returns 24 results (Offset A-F: 24 =
4*6). When set to 12, returns 48 results (Offset A-L: 48 = 4 * 12).
For MSR, LTE-Advanced FDD/TDD, and 5G NR Modes, this trace includes only
outer offset results.
# Item
1 Lower offset A - relative limit result
2 Lower offset A - absolute limit result
3 Upper offset A - relative limit result
4 Upper offset A - absolute limit result
5 Lower offset B - relative limit result
6 Lower offset B - absolute limit result
7 Upper offset B - relative limit result
8 Upper offset B - absolute limit result
... ...
If any result is not available, 1 is returned.
3.5.4 Measurement Results for n = 7
In all cases below:
–
for SA Mode, the values are in the current Y Axis Unit of the instrument
–
if any result is not available, 9.91E+37 (NaN) is returned
Mode Max Number of Carriers
MSR 100
LTEAFDD, LTEATDD 5
5GNR 16
All Others 18
Spectrum Analyzer Mode User's &Programmer's Reference 879