Keysight N9000B - Page 1857

To Next Page

To Previous Page

3 Spectrum Analyzer Mode

3.11 Harmonics Measurement

If a remote command is sent to the instrument that uses one of the Transducer Units

as a terminator, the instrument treats it as though DBUV had been sent as the

terminator.

When a Correction is turned on that uses a Transducer Unit, the Y Axis Unit changes

to that Transducer Unit. All of the selections in the Y-Axis Unit dropdown are then

grayed-out, except the Transducer Unit selection. The unit being used is shown on

this selection in square brackets, and appears on the control in square brackets

preceded by Xducer Unit.

Example:

If the Transducer Unit in the Correction is dBmV/m, then the selection in the

dropdown looks like this:

And on the control it looks like this:

NOTE

If a Transducer Unit is set, it is displayed as Xducer Unit in the Y Axis Unit

dropdown. However, you can only

change

the Transducer Unit via the Edit

Correction dialog in the Input/Output, Corrections menu. In that dialog, tap

Settings then Transducer Unit. You can also turn off Transducer Unit from the

same menu, by selecting None.