3 Spectrum Analyzer Mode
3.13 Phase and Amplitude vs Time Measurement
Phase and Amplitude vs Time Measurement Commands
The following commands and queries can be used to configure the measurement,
then retrieve the measurement results:
:CONFigure:PAVTime
:CONFigure:PAVTime:NDEFault
:INITiate:PAVTime
:FETCh:PAVTime[n]?
:READ:PAVTime[n]?
:MEASure:PAVTime[n]?
Remote Command Results for Phase and Amplitude vs Time
The following table describes the results returned by the FETCh, MEASure, and
READ queries listed above, according to the index value n. All the return values are
floating point numbers in scientific notation, they are listed in the table as integers
or simple real values for readability. If no result is available, NaN (9.91E+37) is
returned.
n Results Returned
0 Returns the number of measured segments (points)
not specified
or 1
Returns scalar results for the segments measured in quadruple format, Phase, Amplitude, Time and Delta
Frequency Error
1948 Spectrum Analyzer Mode User's &Programmer's Reference
To Next Page
Loading...
