99
Key Reference
BW/Avg
When trace average is on, the average type is shown on the
left side of the display. Selecting an average type manually
causes the analyzer to use that type without regard to other
analyzer settings and sets Avg Type to Man.
Key access:
Video Avg Video averaging averages the data as appropriate
for the y- axis scale. When Avg Type > Video Avg is
selected, “VAvg” appears on the left side of the
analyzer display if Average is On.
Key access: > Avg Type
Pwr Avg
Power averaging is performed by converting the
trace data from logarithmic to linear power units,
and then averaging the power trace data. When
Avg Type > Pwr Avg is selected, “PAvg” appears on
the left side of the screen if Average is On.
Key access: > Avg Type
EMI Res BW Press this softkey to select the resolution bandwidth for the
optional EMI filter. This filter provides you with CISPR
16- 1- 1 bandwidth (200 Hz, 9 kHz, 120 kHz, and 1 MHz).
Key access:
Sweep Type
Swept FFT
This softkey toggles the Sweep Type between swept mode
and FFT mode. This FFT mode is only available when RBW
is set to 1 kHz, 3 kHz, or 10 kHz.
Key access:
BW/
Avg
BW/
Avg
BW/
Avg
BW/
Avg
BW/
Avg
To Next Page
Loading...
