Key Reference
MODE
150
ASK/FSK Modulation Analysis
Use the arrow keys to highlight the mode you need and
press [ENTER] as a terminator. When this mode is selected,
the ASK/FSK modulation analysis menu will be displayed.
Carrier Freq Sets the modulated carrier frequency.
Key access: > ASK/FSK Modulation Analysis
Symbol Rate This specifies the fundamental symbol rate of the signal to
be analyzed. The values should be positive. The non- positive
value will be converted to 1Hz. The measurement accuracy
will be impacted if this value isn’t set precisely.
Key access: > ASK/FSK Modulation Analysis
Filter Setup Accesses the Filter setup submenu for further configuration.
Key access: > ASK/FSK Modulation Analysis
View Accesses the submenu to select four display mode:
Symbol - displays the binary symbol in full screen/window.
Waveform - displays the signal waveform.
ASK Error - displays the ASK error.
Eye Diagram - Displays the Eye diagram.
Key access: > ASK/FSK Modulation Analysis
MODE
MODE
Meas
Filter
Selects the Measure Filter as Root Nyquist,
Nyquist, and Gaussian.
Ref Filter Selects the Measure Filter as Root Nyquist,
Nyquist, and Gaussian.
Alpha/BbT Sets the root- off factor α for Root Nyquist and
Nyquist filter or BbT for Gaussian filter.
Filter
Symbols
Sets the symbol numbers for the selected filter.
The allowed value range is from 2 to 25.
MODE
MODE
To Next Page
Loading...
