151
Key Reference
MODE
X Scale Accesses the submenu to configure the X scale parametes:
Scale/Div sets the number of symbols in one division.
Ref Value sets the starting value in term of times at the
reference position.
Ref position sets the display reference position to either Left,
Ctr (center), or Right. If the Auto scale key is set to on, these
parameters are adjusted automatically according to the
measurement result.
Key access: > ASK/FSK Modulation Analysis
Y Scale Accesses the submenu to configure the X scale parametes:
Scale/Div sets the number of symbols in one division.
Ref Value sets the starting value in term of times at the
reference position.
Ref position sets the display reference position to either Top,
Ctr (center), or Bottom.
The Ext Gain is set to add the external gain to the test result.
If the Auto scale key is set to on, these parameters are
adjusted automatically according to the measurement result.
Key access: > ASK/FSK Modulation Analysis
Meas Length Sets the number of symbols which will be used in
calculating the measurement.
Key access: > ASK/FSK Modulation Analysis > More
Average
On Off
Specifies the display measurement result format. When the
Average Number is set to off, the column title "Average" in
numerical results view will be changed to "Current".
Key access: > ASK/FSK Modulation Analysis > More
MODE
MODE
MODE
MODE
To Next Page
Loading...
