Keysight N9320B - Power Preset Last

Getting Started
Helpful Tips
26
Press {IP Select Static} to manually set the IP address, gateway
and subnet mask with the proper LAN information, or just
press {IP Select DCHP} to set the IP address in LAN
dynamically according DCHP.
Press {Apply} to enable all the parameters you set.
Press > {IO Configure} > {LAN} to enable the LAN
connection according to the IP configuration you set.
GPIB
Press > {More} > {More} > {GPIB Address} to set the GPIB
address for the analyzer.
Press > {IO Configure} > {GPIB} to enable the GPIB
connection. The GPIB softkey is only vaild after the option
G01 installed.
Power Preset Last
The option C20 provides the capability to save the last state
of the analyzer before power off/power failed (essentially
uplugging, replugging).
Press > {Pwr On/Preset} > {Power On Last} to activate this
function. For the standard N9320B, this operation only save
the last state if the analyzer is turned off by the front panel
power switch.
Preset/
System
Preset/
System
Preset/
System
Preset/
System