149
Key Reference
MODE
Single When the analyzer is in continuous sweep mode, pressing
this softkey will change the sweep setting to single sweep. It
will then begin a sweep after the trigger conditions are met.
If the analyzer is already in single sweep, pressing this
softkey will execute a new sweep as soon as the trigger
condition is met.
If average is on pressing this softkey will halt averaging of
the current value, and then continue averaging from the
current count number when a single sweep function triggers.
Key access: > AM/FM Modulation Analysis > More
CarrFreq Step Changes the step size for the center frequency function.
Once a step size has been selected and the center frequency
function is activated, the arrow keys change the center
frequency by the step- size value. The step size function is
useful for finding harmonics and sidebands beyond the
current frequency span of the analyzer.
Key access: > AM/FM Modulation Analysis > More > More
Auto CarrFreq
On Off
This function can remedy the carrier frequency deviation
when the deviation less than symbol rate 5.
Key access: > AM/FM Modulation Analysis > More > More
Attenuation
Auto Man
Toggles the input attenuation between Auto or Man. Please
refer to page 90 for further information.
Key access: > AM/FM Modulation Analysis > More > More
Preamp
On Off
Toggles the internal preamp between On and Off. Please
refer to for page 91 further information.
Key access: > AM/FM Modulation Analysis > More > More
MODE
MODE
MODE
MODE
MODE
To Next Page
Loading...
