157
Key Reference
Peak Search
Peak Table Accesses the following Peak Table softkeys to set a peak table.
Key access: > More
Excursion &
Threshold
When Peak Search Type is Excursion &
Threshold, a peak search places a
marker on a peak that meets the
Peak Excursion and Peak Threshold
parameters. If Peak Search Type is
Excursion & Threshold and no peak
satisfies the selected parameters, a
marker is placed at the center of
the trace, and the error message,
“No Peak Found” will appear.
Peak Table
On Off
Displays a list of up to 12 signal peaks that is
updated at the end of each sweep. The peak
table function works with trace 1 only.
Key access: > More > Peak Table
Peak Sort
Freq Amptd
Switches the peak table sorting routine
between listing the peaks in order by
descending amplitude or frequency.
Key access: > More > Peak Table
Peak
Search
Peak
Search
Peak
Search
To Next Page
Loading...
