Key Reference
Preset/System
160
Pwr on/Preset Accesses the following softkeys for the preset settings.
Key access:
Alignment Accesses the following softkeys that align the internal
circuitry of the analyzer, load default values for the
alignment system, and adjust the 10 MHz reference.
Key access:
Upgrade Enables the firmware upgrade process once the USB disk
with the firmware upgrade package plug connected.
Key access:
Power on
Last Preset
Determines the state of the analyzer when the
analyzer is turned on. Power On set to Preset
recalls the analyzer settings previously with the
Preset function. Power On set to Last recalls the
analyzer settings when the analyzer is turned off
by the front panel power switch.
Preset Type Selects User or Factory preset settings.
User Pressing Preset recalls the analyzer
settings defined by Save User Preset.
Factory Pressing Preset recalls the analyzer
settings originally set at the factory.
Save User
Preset
Saves the active settings of the analyzer into the
User Preset register. To recall these settings,
select Preset Type to User.
Preset/
System
Align Accesses the Align softkeys.
All
(Ext Cable)
Initiates the alignment of systems
with a cable connected from the CAL
OUT to RF IN (Except option TG3).
CAL OUT
On Off
Turns the internal amplitude
reference signal on or off. When this
signal is on, the RF input is disabled.
Preset/
System
Preset/
System
To Next Page
Loading...
