Keysight S5040A Open RAN Studio Player and Capture Appliance User’s Guide 25
Getting Started 2
Note that all ports shown in Figure 5 use SMA connectors.
Figure 5 Close-up view of the S5040A SMA ports
5Trig 1-4
(functionality is
described further)
Conforms to SMA
Max Input: 0.0 V to +3.3 V
Min Input: 100 mVpp
Input impedance: 50 ohm or 10K ohm, user selectable
Input threshold: 0.0 V to +3.3 V (in 10 mV increments)
Output: 0.0 V / +3.3 V into high impedance, 0.0 V / +1.65
V into 50 ohm
Max Toggle Rate: 200 MHz
6 FPGA Config Factory use only. Not intended for general use.
7 System Sync Not currently supported
8 GPIO Not currently supported
9 USB USB 3.0 host ports
10 Ground Jack Frame Earth Ground (for ESD strap plug-in)
Label# Connector Description
The QSFP communication cables (or any other with potential laser
energy) are not sold as part of the equipment and as such the unit has no
laser safety classification. The QSFP communication cables used must
be compliant with the requirements of the authorities having jurisdiction
where the equipment is used.
To Next Page
Loading...