Keysight u2722a - Introduction and Product Overview

1 Getting Started
18 Keysight U2722A/U2723A User’s Guide
Introduction
The Keysight U2722A/U2723A USB Modular Source Measure Units (SMU) can
operate as a standalone or modular unit when used in a chassis. The U2722A/
U2723A has three outputs.
The voltage range is –20 V to 20 V, whereas the maximum current output per
channel is 120 mA. The U2722A/U2723A is controlled remotely over a USB
interface via the Keysight Measurement Manager software. The U2722A/U2723A
can also be programmed using the provided drivers or via SCPI commands.
The U2722A/U2723A has the following features.
– voltage source or current source operation
– measurement capability for low current down to nA levels
– high resolution current setting for the low current range at 100 pA
The U2722A/U2723A has the following capabilities.
– voltage and current programming/readback
– programming syntax error detection
– user calibration and self-test capability
U2723A USB Modular Source Measure Unit
The U2723A USB Modular Source Measure Unit has the following features and
capabilities in additional to the U2722A USB Modular Source Measure Unit:
– embedded test script (able to support three channels with coherent source
and measurement capabilities)
– IV Curve application support in the Keysight Measurement Manager software
–Increased (faster) rise/fall time
WARNING
Floating the U2722A/U2723A output more than ±60 VDC from the chassis
presents an electric shock hazard to the operator. Do not float the outputs
more than ±60 VDC when uninsulated sense wires are used to connect the
OUTPUT+ to the SENSE+ and the OUTPUT– to the SENSE– terminals of the
unit.