2 Operation and Features
36 Keysight U2722A/U2723A User’s Guide
Source voltage operation
To set up the U2722A/U2723A for source voltage operation, proceed as follows.
Keysight Measurement Manager operation
1 Connect a load to the output terminals.
Turn off the U2722A/U2723A power. Connect a load to the OUTPUT+ and
OUTPUT– terminals of an output channel.
2 Turn on the U2722A/U2723A.
The U2722A/U2723A will go into a power-on or reset state; the output is
disabled. Ensure that the USB interface has already been connected between
the U2722A/U2723A and PC. Run the Keysight Measurement Manager
software to control the U2722A/U2723A remotely.
On the application panel as shown in Figure 2-2, select the channel that you
have connected. Select the required voltage and current ranges. Otherwise,
enable Auto Range for both voltage and current. Proceed to select Source
Voltage.
Figure 2-2 Panel view of the Keysight Measurement Manager
To Next Page
Loading...
