Digital Multimeter Operation 2
Math Operations
U3606A User’s and Service Guide 65
The primary display briefly shows “PASS” when readings are within the
specified limits, “HI” when the reading is above the high limit, and “LO”
when the reading is below the low limit.
Each time the input value transitions from “PASS” to “HI” or from “PASS”
to “LO”, or when transitioning directly from “HI” to “LO” or “LO” to “HI”,
the instrument beeps once (if the beeper is enabled).
Press Shift > Exit to exit the limit mode.
To Next Page
Loading...
