Features of your vehicle
344
Mirrors
the type of mirror control installed. The
mirror heads can be folded back to pre
-
vent damage during an automatic car
wash or when passing through a narrow
street.
Rearview mirrors
僅 The outside rearview mirror is convex.
Objects seen in the mirror are closer
than they appear.
僅 Use your interior rearview mirror or
direct observation to determine the
actual distance of following vehicles
when changing lanes.
Do not scrape ice off the mirror face; this
may damage the surface of the glass. If
ice should restrict the movement of the
mirror, do not force the mirror for
adjustment. To remove ice, use a deicer
spray, or a sponge or soft cloth with
warm water.
If the mirror is jammed with ice, do not
adjust the mirror by force. Use an
approved spray de-icer (not radiator
antifreeze) to release the frozen mecha
-
nism or move the vehicle to a warm
place and allow the ice to melt.
Do not adjust or fold the outside rear
-
view mirrors whilst the vehicle is moving.
This could result in loss of control, and
an accident which could cause death,
serious injury or property damage.
Adjusting the outside rearview
mirrors
The electric remote control mirror switch
allows you to adjust the position of the
left and right outside rearview mirrors.
Adjusting the rearview mirrors:
1. Move the R or L switch (1) to select the
right side mirror or the left side mirror.
2. Press a corresponding point (▲) on
the mirror adjustment control (2) to
position the selected mirror up, down,
left or right.
僅 The mirrors stop moving when they
reach the maximum adjusting angles,
but the motor continues to operate
whilst the switch is pressed. Do not
press the switch longer than neces
-
sary, the motor may be damaged.
僅 Do not attempt to adjust the outside
rearview mirror by hand. Doing so
may damage the parts.
Folding the outside rearview mir
-
ror
Manual type
To fold the outside rearview mirror:
僅 Grasp the housing of the mirror and
then fold it toward the rear of the
vehicle.
To Next Page
Loading...
