EasyManua.ls Logo

Kia Sonet 2024 - 僅 Cargo Area Cover; 僅 Floor Mat Anchor(S)

Kia Sonet 2024
429 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
97
4
4
Features of your vehicle Interior features
1. Lift the curtain by the knob (1).
2. Hang the curtain on both sides of the
hook.
NOTICE
Always hang both sides of the curtain
on the hook. This could cause damage
to the side curtain if only one side of
the curtains is hooked.
Do not let any foreign materials get in
between the door trim and side cur
-
tain. The side curtain may not be lifted
up.
Floor mat anchor(s) (if equipped)
When using a floor mat on the front floor
carpet, make sure it attaches to the floor
mat anchor(s) in your vehicle. This keeps
the floor mat from sliding forward.
WARNING
Aftermarket floor mat
Do not install after market floor mats
that are not capable of being securely
attached to the vehicle's floor mat
anchors.
Unsecured floor mats can interfere
with pedal operation.
Use floor mats not too thick and
designed to be properly secured on
the floor to avoid the interference with
pedals. Make sure that installing the
floor mats without removing plastic
films on carpets may damage or
break floor mat fix rings, resulting in
the mats to be unsecured. Especially
for a driver's seat, the unsecured mats
may cause unintended acceleration/
brake. Ensure to remove all the plastic
films on the carpets before installing
the mats.
The following must be observed when
installing ANY floor mat to the vehicle.
Ensure that the floor mats are
securely attached to the vehicle's floor
mat anchor(s) before driving the vehi
-
cle.
Do not use ANY floor mat that cannot
be firmly attached to the vehicle's
floor mat anchors.
Do not stack floor mats on top of one
another (e.g., all-weather rubber mat
on top of a carpeted floor mat). Only a
single floor mat should be installed in
each position.
Cargo area cover (if equipped)
Use the cargo area cover to hide items
stored in the cargo area.
Removal and installation
To remove the cargo area cover:
1. Remove straps from both sides of the
cargo area cover.
2. Whilst lifting the cover up, hold the
area near the front slots. Then, pull up
the cover at approximately 45 ° angle.
WARNING
Do not place objects on the cargo area
cover. Such objects may be thrown
OQYi033078
OQYi033036

Table of Contents

Related product manuals