49
4
4
Features of your vehicle LCD display
AUTO STOP (if equipped)
A: Timer
AUTO STOP display shows the elapsed
time of engine stop by Idle Stop and Go
(ISG) system.
If the ISG does not operate, the reason
for the non-operation is displayed. (if
equipped)
For more details, refer to "Idle Stop and
Go (ISG) system" on page 5-36.
Digital speedometer (if equipped)
Indicates the speed of the vehicle.
Service mode
This mode reminds you of scheduled
maintenance information.
Service in
It calculates and displays when you need
a scheduled maintenance service (mile
-
age or days).
If the remaining mileage or time reaches
1,500 km (900 miles) or 30 days, "Ser
-
vice in" message is displayed for several
seconds each time you set the ignition
switch or ENGINE START/STOP button
to the ON position.
Service required
If you do not have your vehicle serviced
according to the already inputted ser
-
vice interval, "Service required" message
is displayed for several seconds each
time you set the ignition switch or
ENGINE START/STOP button to the ON
position.
To reset the service interval to the mile
-
age and days you inputted before:
僅 Press the OK button (Reset) for more
than 1 second.
If any of the following conditions occurs,
the mileage and days may be incorrect.
僅 The battery cable is disconnected.
僅 The battery is discharged.
Driving info display
At the end of each driving cycle, the
Driving Info message is displayed.
A:
Drive info
1
Accumulated trip distance
2
Average fuel efficiency
3
Total driving time
This display shows the trip distance (1),
average fuel economy (2), driving time
(3).
This information is displayed for a few
seconds when you turn off the vehicle,
and then goes off automatically. The
information is calculated for each time
the vehicle is turned on.
To Next Page
Loading...
