63
4
4
Features of your vehicle Lighting
The ignition switch must be in the ON
position to turn on the headlights.
Auto light (if equipped)
When the light switch is in the AUTO
light position, the taillights and head
-
lights will turn ON or OFF automatically
depending on the amount of light out
-
side the vehicle.
僅 Never place anything over the sensor
(1) located on the instrument panel as
this will ensure better auto-light sys
-
tem control.
僅 Don't clean the sensor using a window
cleaner, the cleaner may leave a light
film which could interfere with sensor
operation.
僅 If your vehicle has window tint or
other types of metallic coating on the
front windscreen, the Auto light sys
-
tem may not work properly.
Operating high beam
To turn on the high beam headlamp:
1. Push the lever away from you.
The lever will return to its original
position.
The high beam indicator will light
when the headlight high beams are
switched on.
Do not use high beam when there are
other vehicles. Using high beam could
obstruct the other driver's vision.
To flash the headlights:
1. Pull the lever towards you.
It will return to the normal (low beam)
position when released. The headlight
switch does not need to be on to use this
flashing feature.
Operating turn signals and lane
change signals
The ignition switch or ENGINE START/
STOP button must be ON for the turn
signals to function.
To turn on the turn signals:
僅 Move the lever up or down (A).
The green arrow indicators on the
instrument panel indicate which turn
signal is operating.
To Next Page
Loading...
