Chapter 2: Front panel programming
114 P/N 3102351-EN • REV 005 • ISS 28DEC18
4. Choose MSK.
5. Enter the network card’s subnet mask number.
6. Choose GWY.
7. Enter the network card’s gateway number.
8. Choose Save.
9. Press the Menu button to exit menu mode, or continue programming.
Port CU programming
To communicate with the CU, you must enter the same TCP/IP port number that you defined
in the CU’s TCP IP Port field.
To set the port CU:
1. Display the panel configuration options menu. See “Panel programming” on page 102.
2. Choose Port CU.
3. Enter the TCP/IP port number (1025 to 65535) that you entered in the Configuration Utility.
The default is 2505. (Ports 1 to 1024 are reserved.)
Setting the Lock Remote Read function
Lock remote read controls incoming TCP/IP communications when a network card is installed
and it is connected to a LAN or WAN. It restricts telnet, ping, and CU read requests at the
panel so that unwanted access to the panel is restricted, almost like a firewall.
Note: If lock remote read is set to Yes, it remains active when no one is logged on to the panel
or when someone uses a level one password to log on. When you log with a level two
password, all communication options are available and there are no restrictions.
To set the Panel Configuration lock remote read option:
1. Display the panel configuration options menu. See “Panel programming” on page 102.
2. Choose Lock Rmt Read.
3. Select either:
Yes: telnet, ping, and CU read access to the panel are restricted.
No: telnet is restricted, but ping and CU read access to the panel are allowed.
4. Program other panel configuration options or choose Save if you’re finished.
5. Press the Menu button to exit menu mode, or continue programming.
To Next Page
Loading...
Need help?
General
