TOS8030 Safety Precautions 5
Relocation
• Turn off the POWER switch and disconnect all cables before relocating the product.
• Be sure the operation manual be included when the product is relocated.
Operation
• Before using the tester, check that there are no abnormalities on the surface of
the power cord. (Before doing this, always disconnect the power cord from the
electrical outlet.)
• If any abnormality or failure is detected in the products, stop using it immediately.
Unplug the power cord. Be careful not to allow the product to be used before it is
completely repaired.
• Do not disassemble or modify the product. If it must be modified, contact Kikusui
distributor/agent.
Maintenance and checking
• To avoid electrical shock, be absolutely sure to unplug the power cord before per-
forming maintenance or checking.
• Do not remove the cover when performing maintenance or checking.
• To maintain performance and safe operation of the product, it is recommended
that periodic maintenance, checking, cleaning, and calibration be performed.
Service
• Internal service is to be done by Kikusui service engineers. If the product must be
adjusted or repaired, contact Kikusui distributor/agent.
Check?
To Next Page
Loading...
