3.2.7 Modify the security code
➢ Press OK on “Security code” line.
The following message is displayed : “Modification Security code?”.
➢ Go to “Continue” then press OK.
➢ Enter the current code.
➢ Enter the new code.
➢ Go to “YES” then press OK to confirm the new code.
The transmitter displays a message indicating that the code has been modified.
➢ Press OK.
Keep the new created code because it will be not possible to access to the configuration of the transmitter
with the code 0101.
3.2.8 Back to factory parameters
➢ Press OK on “Back to factory settings” line.
➢ Go to YES then press OK to confirm.
3.2.9 Set the Modbus (optional)
➢ Press OK on “Modbus” line.
➢ Press OK on “Slave num” line.
➢ Enter the slave number with Up and Down keys.
➢ Press OK to validate.
➢ Go to “Communication speed” line then press OK.
➢ Select the speed with Up and Down keys then press OK.
If the Modbus option is selected when ordered the transmitter, the default slave number will be indicated on serial
number label and the default speed is 19 200 bds.
3.2.10 Set the Ethernet communication (optional)
➢ Press OK on “Ethernet” line.
➢ Press OK on “Address” line.
The address consists of 4 groups of numbers.
➢ Set the 1
st
group with the arrows then press OK.
➢ Repeat the procedure for the 3 following groups.
➢ Go to “OK” then press OK to validate the address.
➢ Press OK on “Mask” line.
The mask consists of 4 groups of numbers.
➢ Set the 1
st
group with the arrows then press OK.
➢ Repeat the procedure for the 3 following groups
➢ Go to “OK” then press OK to validate the mask.
➢ Press OK on “Gateway” line.
The gateway consists of 4 groups of numbers.
➢ Set the 1
st
group with the arrows then press OK.
➢ Repeat the procedure for the 3 following groups.
➢ Go to “OK” then press OK to validate the gateway.
➢ Press OK on “Port” line.
➢ Use the arrows to set the port then press OK.
The Address Mac can not be modified because it is linked to the Ethernet board.
12
To Next Page
Loading...
