Kinco-MK
User Manual
3.2 PLC ...................................................................................................................................22
3.2.1 introduction ................................................................................................................22
3.2.2 Install driver of USB programming port ................................................................... 22
3.2.3 High speed counter .................................................................................................... 33
3.2.3.1 Operation Modes and Inputs of the High-speed Counters ..................................34
3.2.3.2 Control Byte and Status Byte ................................................................................. 35
3.2.3.3 Preset value (PV value) setting ...............................................................................37
3.2.3.4 “CV=PV” Envent No. .............................................................................................39
3.2.3.5 How to use high speed counter ...............................................................................40
3.2.4 How to use high speed pulse output ..........................................................................41
3.2.4.1 High speed pulse output instruction ....................................................................... 42
3.2.4.2 How to use PLS instruction ....................................................................................42
3.2.4.2.1 High-speed Pulse Output Function of HMI-PLC .........................................43
3.2.4.2.2 PTO/PWM Register ......................................................................................45
3.2.4.2.3 PTO Operations ......................................................................................... 47
3.2.4.2.4 PWM Operations .......................................................................................... 49
3.2.5 How to Use Position Control Instructions ..............................................................50
3.2.5.1 How to Modify the Current Value of Position Control Instructions ......................50
3.2.5.2 Can it change maximum output frequency when position control instruction is
executing? ........................................................................................................................... 52
3.3 The use of analog quantities .............................................................................................53
3.3.1 Wiring diagram .......................................................................................................53
3.3.2 Measurement Ranges and The measured value Representation ............................... 53
3.3.3 Configuration in software ..........................................................................................54
To Next Page
Loading...
