Kinco-MK
User Manual
3.2 PLC
3.2.1 introduction
Kinco MK series use Kincobuilder programming software and same instructions, same as HP
series.And MK070E improve some functions, pls reference the manual.
Pls reference Kincobuilder software 【Help】or download K5/K2 software for most functions.
https://en.kinco.cn/Download/D_enUserManual/PLC/Software%20manualfor%20K5_2019051
6.zip
3.2.2 Install driver of USB programming port
MK series provide USB programming port. This programming port will be used as virtual
serial port in PC. Its driver files are located in \drivers in Kincobuilder installation folder. Right
now it supports Windows XP、Windows 7、Windows 8 and Windows 10 systems, as shown in
following figure:
When connecting programming cable to MK series and PC first time, Windows system will
detect new hardware and mention installing driver, users can install the driver according to the
version of Windows.
Fail in installing driver in Windows 7?
If it is simplified Win7 system, it will be lack of files mdmcpq.inf and usbser.sys, so it can not
install the virtual serial port.
These two files are in the path ..\Win7\windows, users can copy these two files to following
path and install the driver again.
Copy mdmcpq.inf to C:\WINDOWS\INF.
Copy usbser.sys to C:\WINDOWS\SYSTEM32\DRIVERS\
To Next Page
Loading...
