Kinetico K5 - Page 22

K5 Drinking Water Station
Section 7 Drinking Water Systems Revised: 09/2016
Page 22
plug
inserted
into port
11. Remove cartridge
12. Add 5 mL unscented
bleach to a sanitization
cartridge that is half full
of clean water
13. Install RO
WARNING: Handle cartridge with care
when removing. May contain chemical
solution.
14. Remove ⅜” plug from
yellow port on manifold
and insert ⅜” tube into
same yellow port. Place the
other end into a 5 gallon
bucket.
15. Open jack screw
completely
16. Slowly open feed valve
17. Fill bucket
18. Close feed
19. Close jack screw
20. Remove ⅜” line and
replace plug in yellow port.
WARNING:
Do not overflow.
Note: Do not over tighten.
prefilter position
⅜” plug