Kinetico K5 - Cartridge Change; Sanitation Procedures

K5 Drinking Water Station
Revised: 09/2016 Drinking Water Systems Section 7
Page 27
Cartridge Change
Sanitation Procedures
Sanitization Procedure for K5 WOW – Chlorine Dioxide
1. Close feed.
2. Open faucet to
depressurize system.
3. Attach anti-spray line and
close faucet.
anti-spray line
4. Remove postfilter and
install cartridge plug.
5. Open feed.
6. Open faucet to empty
permeate from storage tank.
postfilter
cartridge plug
7. Close feed.
8. Wait 3 minutes.
9. Close faucet.
10. Turn jack screw completely
(clockwise).
11. Remove all remaining
cartridges.
12. Install cartridge plugs in
these locations, except
prefilter.
Note: Do not
over tighten.
cartridges
Install 4 plugs in these locations.
(RO, Auxiliary 1, Auxiliary 2, Post)