2）In accordance with the above-mentioned in the same way, you can adjust the flight pattern of
N, 1,2 under the gyroscope sensitivity value of the lock, pulled GC switch to 1, on the screen
display you will see GYR-FRE, at the same time, and then hold down both the and
keys, GYR - FRE characters blinking, into the "lock-set value of the" state of rotation 5
Gyroscope channel knob adjustment sensitivity to the appropriate location, GC will switch
hit 2 (GYR-HOD), at this time of the gyroscope sensitivity memory output value was down by
Under the ENT button to confirm, set from the state. After the GC as long as the switch hit 2
position gyroscope sensitivity automatically to maintain output at that level, do not have
in-flight re-adjustment knob Channel 5.
state. Just after 2 position of TC hit switches, power output would automatically be maintained
at this level.
page 12
12.MIXING FUNCTION
Press SET key until TYPE is blinking. Next press ENT key to confirm you choice then press
SET key to have MIX blinking. AIL-MIX will display on the sreen. This means that the “master”
servo is AIL-MIX servo. User can select any other servos as master ELE-MIX,THR-MIX,
RUD-MIX,GEA-MIX,FLP-MIX,AUX1-MIX,AUX2-MIX，to do that he need press SEL key.
The CH line display the master mixing control servo. Pressing CH change the slave servo to
mix with master. Next user need to adjust the rate of mixing with or keys. At the
end press ENT. You will see the screen asking you YES/NO. After selecting YES (will blink)
press ENT to confirm.
13.STICK CALIBRATION AND STICK MODE
Important remarque: User should make a stick calibration before to make a change to
stick mode.
To make a stick calibration first move all sticks(aileron, throttle, rudder and elevator) to middle
position. Push SET key until TYPE is blinking, then press SEL+CH key, “MOD1” will display.
Push or and shorty after, when STK AIM is on screen push ENT.
To change left/right hand mode press SET key until TYPE is blinking, then press SEL+CH key,
“MOD1” will display on the screen. Pressing or key, will display “MOD2”. At moment you
see MOD2 push ENT key.
To verify if the mode really has change move Trottle stick. Moving Trottle key should display
small triangle above Trottle channel on display.
Note: If you change the stick mode,peease make stick calibration.
To Next Page
Loading...