EasyManua.ls Logo

KING MAX T810 - The Main Features; Receivers Antenna Installation

Default Icon
20 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
THE MAIN FEATURES
1. Digital Synthesis .There is no need to replace crystal; Automatic frequency selection to avoid
interference with other communications.
2. Automaticly scanning receivers, High sensitivity and high-performance anti-jamming combination.
3. PCM 1024, high accuracy and large range , jumping to the total elimination of drift and rudder
problems.
4. Large-screen liquid crystal display with backlight. Through the user interface settings menu,
you can adjust all parameters, Programming give the possibility to control a variety of aircraft
types.
5. And the proportion of action to respond to manipulation of any adjustable curve. Can switch
in flight, will also be able to meet the needs of learners with special needs.
6. User programmable mixed-control mode To meet the exigence of variety types of
helicopters. In case of airplanes possibility of controlling V-shaped tail, Delta-wing, as well as
other special needs to control the model.
7. 9 memory storage 8. Fail safe setting 9. Throttle cut
page 3
RECEIVER’S ANTENNA INSTALLATION
MPORTANT: Since the 2.4GHz have different characteristics than that of the conventional
27MHz and 72MHz frequencies, please read this carefully to enjoy safe flight
with the 2.4GHz system.
1. Keep the antenna away from the motor, ESC,and other noise sources as much as possible.
2. Be very careful when handling the receiver antennas. Repeated motion in and out of the case
 holes or excessive pulling forces could break or compromise the internal antenna connections.
3. The antenna should be placed at a 90 degree angle to the centre AXIS of model. This is not
a critical figure, but is very important to have a good range.
4. The antenna must be kept away from conductive materials, such as metal and carbon by at
least a half inch. The coaxial part of the antennas does not need to follow these guidelines,
but do not bend it in a small radius.
5. If the fuselage is made of conductive material such as metal and carbon, the antennas part
must be placed outside of the fuselage. In addition to that , do not attach the antenna part on
the fuselage. Installing the RECEIVER into that kind of fuselage, this guideline must be kept.
Antenna Coaxial cable
KING MAX