KING MAX T810 - Installation Diagram; Helicopters System Setting

1． SEL: To Select model, to adjust the time, radio frequency modulation and frequency channel
and so on
2． SET: To select the menu function, the parameters of servos or the type of aircraft, and so on.
3． CH： The choice of channel
4． : To increase the value of parameters
5. : To decrease the value of parameters
6． ENT： button to confirm the adjustment
7． TC： Throttle Control switch.
（1:Throttle free
0:Throttle cut
2:Throttle hold）
8． GC： Gyroscope sensitivity control switch.
（1:Gyro free
0:Gyro cut
2:Gyro hold）
9. D/R： Dual Rates Settings
10. IDLE： Used to set THROTTLE curve and PITCH curve for idle state during the flight.
11. AUX1 ：7-channel control switch.
12. AUX2： 8-channel control switch.
page 5
HELICOPTER SYSTEM SETTING
AUX2(CH8)
AUX1(CH7)
Pith Or Flap Servo
(CH6)
Gear Servo Or Gyro
(CH5)
Rudder Servo (CH4)
Throttle Servo (CH3)
Elevator Servo (CH2)
Aileron Servo (CH1)
OFF
ON
BATTERY
SWITCH
RECEIVER
ANTENNA
1. INSTALLATION DIAGRAM:
UBEC
ESC
SIGNAL
+
-