Switch IDLE to "N", TC switch to 1. On the screen display you will see "THR-FRE" , at the
same time, by holding down both the and keys so that the key to THR-FRE blinking
characters, said Into the "lock throttle to set the value of the" state of throttle push rod
engine to idle operation, the number of field observation showed that at this time of the
stroke volume. Speed in an appropriate value, the TC will switch hit 2 (THR-HOD) position,
11. THROTTLE AND GYRO SENSITIVITY LOCK
page 18
the current value of the gas output was down memory, the process can be repeated until a
satisfactory value of the throttle lock, the final press ENT button to confirm , Set from the
state. Just after 2 position of TC hit switches, power output would automatically be maintained
at this level.
12.MIXING FUNCTION
Press SET key until TYPE is blinking. Next press ENT key to confirm you choice then press
SET key to have MIX blinking. AIL-MIX will display on the sreen. This means that the “master”
servo is AIL-MIX servo. User can select any other servos as master ELE-MIX,THR-MIX,
RUD-MIX,GEA-MIX,FLP-MIX,AUX1-MIX,AUX2-MIX，to do that he need press SEL key.
The CH line display the master mixing control servo. Pressing CH change the slave servo to
mix with master. Next user need to adjust the rate of mixing with or keys. At the
end press ENT. You will see the screen asking you YES/NO. After selecting YES (will blink)
press ENT to confirm.
13.STICK CALIBRATION AND STICK MODE
Important remarque: User should make a stick calibration before to make a change to
stick mode.
To make a stick calibration first move all sticks(aileron, throttle, rudder and elevator) to middle
position. Push SET key until TYPE is blinking, then press SEL+CH key, “MOD1” will display.
Push or and shorty after, when STK AIM is on screen push ENT.
To change left/right hand mode press SET key until TYPE is blinking, then press SEL+CH key,
“MOD1” will display on the screen. Pressing or key, will display “MOD2”. At moment you
see MOD2 push ENT key.
To verify if the mode really has change move Trottle stick. Moving Trottle key should display
small triangle above Trottle channel on display.
Note: If you change the stick mode,peease make stick calibration.
To Next Page
Loading...