14. SELF-HELP MOVEMENT OUT OF CONTROL(FAIL SAFE)
15. RESET SETTING
Model lost in the remote control transmitter signal when the implementation of dynamic
self-help movement. This action is stored in a set of 8-channel receiver, by the user to set
their own store.
Method: Open the first remote control transmitter, receiver after the opening, to ensure
that the receiver Always light, can be normal to accept instructions. Press the button on
the receiver to keep 2 seconds until the light is off, said the store began to manipulate the
page 19
action, this time to send button to open soon in the remote control transmitters operate on
self-help movement to do that in 5 seconds after the re-turn on the light before the operation
In the remote control transmitter made on the operation of action will be down the memory.
If the indicator light turns off so that the buttons did not release the button until the indicator
light to turn on, it will lift the self-storage process moves.
Press SET key to SERVO blink, then press down SEL+ CH keys and You will hear “DI”
sound as confirmation.
CONTENTS:
Transmitter:T810 PCM1024,2.4GHz
Modulation mode: DSSS
Operating system: 2- stick, 8- channel system
Power supply: 11.1V Li-Poly battery
Power consumption: 300mA
RECEIVER: R810
8- channels receiver of DSSS system
receiving on 2.4GHz band
Power requirement: DC5V or DC6V
Power consumption:30mA
* Note: Never use dry battery for T810,please use Li-Poly battery for R810.
To Previous Page
Loading...