4、Installation Instruction
Fix the display and 30-button unit on the handlebar and
adjust to an appropriate visual angle. Match display
connector with controller connector.
5、Set up
5.1 Preparation for Starting the Display
Make sure connector linked properly to the motor controller
on the bike.
5.2 Start and Entry Setting State
Press the MODE button for 1.5 seconds and start the
display.
After start-up, please hold both UP and DOWN for 2.5
seconds at the same time, LCD will enter into the setting
state，and the settable parameter will flash. The parameter
can be set circularly.
5.3 Wheel Diameter
The first setting parameter is wheel diameter. The interface
is as follows:
To Next Page
Loading...
