28
Step 4: Place rocks #1 into position as
shown.
Step 5: Place rocks #3 and #6 into
position as shown.
Step 6: Place rocks #3 into position as
shown. Place the rock #3 that is high-
lighted over the single porting crossover
area as shown.
Step 7: Place rock #1 into position as
shown.
MQRSP7 Rock Support Platform and MQROCK1
Finished setup and burn
If too much flame impingement on the rocks causes sooting, you may
have to move or remove one or more rocks. Do not place rocks directly
over top of the burner tube.
To Next Page