DP770 Service Manual
4.2. Parameters Setting
Radios have default parameters. While users can set parameters of frequency, channels, function of
scanning or encryption, etc according your own requirements.
• Parameters setting steps as follow:
Step 1. Install the right version of Kirisun CPSp.
Step 2. Connect radio with computer by Kirisun programming cable.
Step 3. Make sure radio’s power is on.
Step 4. Execute CPSp and start operation.
• CPSp installation steps as follow:
Step 1. Double click the installation file; pop-up interface as Figure 4-1.
Figure 4-1
S
tep 2. Click “Next” and enter into the next interface to choose the installation route.
Step 3. In the interface shown in Figure 4-2, users can click “Browse” to choose the installation route, or
use the default route, and click ”Next” to enter the next interface to choose language.
Figure 4-2
Page 14 of 102
To Next Page
Loading...
