n Always clean the interior with a damp cloth to prevent electro-
static charging.
n Exclusively use the LABEX
®
interior fittings.
5.2 Installing the unit
LABEX
®
105 PRO-ACTIVE LABEX
®
126 PRO-ACTIVE
Have the unit installed only by staff qualified for the task. If in
doubt, contact KIRSCH
Ä
“Manufacturer’s address” on page 4.
Install the unit as shown in the installation drawing provided.
5.3 Connecting the unit
The unit is designed according to protection class I
and protection type IP 20 and is ready to be
plugged in.
Ensure the connection conditions specified in the technical data
and on the type plate.
1. Check the connecting cable of the power plug for damage.
2. Plug in power plug.
Overview of units suitable for
installation
Installing
Connecting
Set-up, installation and connection
Connecting the unit
27.05.2021Refrigerator/freezer LABEX® series34
To Next Page
Loading...
