Klein 5000 V2 Series - Figure 4-2: Tail Cone Being Aligned and Attached to Towfish

4-4 CHAPTER 4 Maintenance and Troubleshooting
Series 5000 V2 Sonar System Operations and Maintenance Manual P/N 11214512, Rev. 04
2. With the large hole to the
upper right, align the tail
cone with the rear center
pin and thread the rear tail
cone bolt (7) into the rear
center pin using the 8-mm
hex key.
3. Using the pliers, tighten the
rear tail cone bolt (7). Do
not overtighten.
Figure 4-2: Tail Cone being Aligned and
Attached to Towfish
Figure 4-3: Tail Cone Being Tightened with Hex
Key