10
CARE SHOULD BE TAKEN DURING SET-UP AND ASSEMBLY OF
THIS PRODUCT. DEATH OR SERIOUS INJURY COULD OCCUR IF PROPER
STEPS ARE NOT TAKEN TO FULLY SECURE THE UNIT WHEN WORKING
UNDERNEATH IT. FOR YOUR SAFETY, ENSURE THE UNIT IS PROPERLY
SUPPORTED BY LOWERING THE JACKSTAND SUPPORTS THAT HAVE
COME ASSEMBLED WITH IT, OR PROPERLY SECURE THE UNIT WITH
ANY HOISTING DEVICES BEFORE ATTEMPTING ANY FURTHER SET-UP
OF THIS PRODUCT. ANY HOISTING DEVICES SHOULD BE RATED TO
FULLY SUPPORT THE LOAD OF THE UNIT BEING LIFTED.
WARNING
2
1
0
KMC P/N 42-050-012
WARNING
MOVE WET LITTER HOLD DOWN
BLOCKS TO STORAGE POSITION
SHOWN IN DIAGRAM.
AND PLACE BUMP PADS AS
BUMP PADS
DRY LITTER OPERATION
IMPORTANT!
MOVE THE WET LITTER HOLD
WET LITTER OPERATION
(WET LITTER)
WORKING POSITION
IN STORAGE CANNISTER.
LITTER. PLACE BUMP PADS
DOWN BLOCKS INTO THE
REMOVE ALL BUMP PADS
WHEN OPERATING IN WET
WORKING POSITION AND
(DRY LITTER)
STORAGE POSITION
TALL BUMP PADS
IMPORTANT!
Jackstand
B l o c k e d
Cylinder Lock-
To Next Page
Loading...
Need help?
General