7
RETAIL CUSTOMERS RESPONSIBILITY UNDER THE KMC WARRANTY:
The retail customer’s responsibilities are:
1. To read the Operator’s Manual and operate the 4265LPD and 4260D
PHC in accordance with the instructions given in this manual.
2. To inspect the 4265LPD and 4260D PHC daily, lubricate as specified
and repair or replace parts as needed, especially when continued use
would cause damage or excessive wear to other parts.
3. To maintain and keep in place all safety shields, decals and devices.
4. When warranty service is necessary, it is the customer’s responsibility to
deliver the machine to the KMC dealer from which it was purchased.
Warranty repairs should be submitted to the dealer within thirty (30)
days of failure.
5. Dealer travel to the machine or hauling the machine to his shop for the
purpose of performing warranty service is not allowed under KMC war-
ranty. It is a cost to be paid for by the retail customer. Any arrangement
whereby the dealer agrees to absorb all or part of this cost is strictly be-
tween the dealer and the retail customer.
1. All persons operating this piece of equipment should READ the
Owner’s Manual.
2. Do not permit anyone to ride on the machine at any time.
3. Before starting or operating the machine, make a walk-around inspection
and check for obvious defects such as loose mounting bolts and dam-
aged components. Correct any deficiencies before starting. (The equip-
ment must be properly maintained and guarded and must be suit-
able to performing its task.)
4. Keep all persons a safe distance away from all sides of the machine while it
is in operation.
SAFETY PROCEDURES:
Safety and performance are the primary
objectives of the designers of KMC
equipment. Safety features have been
incorporated into this machine where possible
and warnings given in other areas. For your
safety, PLEASE read and observe the
following safety procedures.
To Next Page
Loading...
Need help?
General