KMC Controls 42 Series User Manual

6
1. KEEP ALL SHIELDS IN PLACE.
2. STOP ENGINE BEFORE LEAVING OPERATOR’S POSITION TO ADJUST, LUBRI-
CATE, CLEAN OR UNCLOG MACHINES, UNLESS OTHERWISE SPECIFICALLY
RECOMMENDED IN THE “OPERATOR’S MANUAL”.
3. WAIT FOR ALL MOVEMENT TO STOP BEFORE SERVICING THE MACHINE.
4. KEEP HANDS, FEET AND CLOTHING AWAY FROM POWER DRIVEN PARTS.
5. KEEP OFF EQUIPMENT UNLESS SEAT OR PLATFORM FOR OPERATION AND
OBSERVATION IS PROVIDED.
6. KEEP ALL OTHER OFF.
7. USE FLASHING WARNING LIGHTS WHEN OPERATING ON HIGHWAYS EXCEPT
WHEN PROHIBITED BY LAW.
8. MAKE CERTAIN EVERYONE IS CLEAR OF MACHINE BEFORE STARTING ENGINE
OR OPERATION.
02-050-078
33-050-248
 STAND CLEAR OF ALL ROTATING BELT DRIVES
AND CHAIN DRIVEN PARTS.
 ENTANGLEMENT WITH ROTATING DRIVE PARTS
CAN CAUSE INJURY OR DEATH.


SAFETY DECALS
The Safety decals that follow are associated with the implement covered in this owner’s
manual. They should be reviewed and associated with where they are applicable on the
implement being covered.
DRY LITTER OPERATION
BLOCKS TO STORAGE POSITION
MOVE WET LITTER HOLD DOWN
SHOWN IN DIAGRAM.
AND PLACE BUMP PADS AS
IMPORTANT!
LITTER. PLACE BUMP PADS
WORKING POSITION
BUMP PADS
(WET LITTER)
TALL BUMP PADS
(DRY LITTER)
STORAGE POSITION
WET LITTER OPERATION
DOWN BLOCKS INTO THE
MOVE THE WET LITTER HOLD
REMOVE ALL BUMP PADS
WHEN OPERATING IN WET
WORKING POSITION AND
IMPORTANT!
IN STORAGE CANNISTER.
42-050-069

KMC Controls 42 Series Specifications

General

Brand	KMC Controls
Model	42 Series
Category	Cleaning Equipment
Language	English