Section 1
Introduction
20412914
8-2012/Rev 09
1-6
4. Close, lockout and tag the manual shutoff valves for all service connections: cutting water
in, cooling water in and out, and air.
Warning Labels
Warning labels are posted on the machine to indicate potential hazards. The operator and service
personnel shall pay particular attention to these warning labels. Table 1-2 describes the necessary
precautions and provides the part number required to order replacement labels.
Table 1-2
Warning Label Precautions
1
The electrical enclosure and motor junction box can
present an electrical shock hazard. Always disconnect
and lockout the main power before opening the
enclosure.
Always disconnect and lockout the main power and the
circuit breaker/disconnect on the electrical enclosure
door before performing any type of maintenance.
P/N 05114962
2
The surface of high pressure water and hydraulic
components becomes hot during normal operation.
Failed, or failing components, can become extremely
hot during operation.
P/N 05114970
3
Ensure that all protective guards, shields or covers are
in place on the equipment at all times. Never operate
the pump with the guards removed.
P/N 80082209
To Next Page
Loading...
Need help?
General
