Kodak 9000 - Manually Pre-Setting the Patient Positioning

Acquiring a 3D Image
KODAK 9000 3D Extraoral Imaging System_User Guide (SM710)_Ed 01 5–11
in the pane, click to access the patient record and open the
acquired 3D image.
Manually Pre-Setting the Patient Positioning
To pre-set the acquisition parameters, follow these steps:
1. Select the appropriate settings in:
• The Program pane
• The Patient pane
• The Parameter pane if needed
2. To pre-set the patient positioning, ask the patient to bite into a plate of dental plaster and
wait for the plaster imprint to harden.
3. Place the dental imprint on the bite block location. Press and hold to align the
Unit rotative arm to the region of interest using the 3D central positioning laser beam.
Press to save the manually selected parameter settings of the Unit rotative arm.
4. Remove the plaster imprint and position the patient in the Unit and follow the appropriate
steps to acquire the 3D image of the region of interest.
TIP
You can pre-set the acquisition parameters of the region of interest
manually using dental plaster imprint.