Using and Maintaining the Imager
January 17, 2007 8F2927 2-3
Power Failures In the event of a power loss, the 6800 Laser Imager shuts down. Films in
process will not be completed and will remain where they are until they are
removed (see “Correcting Film Jams With the Imager Powered OFF” on
page 3-2).
To restart the Imager after power is restored, turn OFF the power switch on
the Imager and then turn it ON. After warming up, the Imager automatically
reprints any films that were in process when power was interrupted.
NOTE: If the Imager does not restart after pressing the power switch, press
the power button on the local panel (see “Turning Imager Power ON
and OFF” on page 2-1).
Power Save The Imager has a Power Save option, which lets you reduce the power
consumption of the Imager during periods of inactivity. To learn more about
the Power Save option, see the general help information on the touch screen
(see “General Help” on page 2-6).
Using the Touch Screen
Use the touch screen to monitor Imager operations and to control some
Imager functions.
Unlock icon Help icon
Film drawer icons
To Next Page
Loading...
