2-6 8F2927 January 17, 2007
Using and Maintaining the Imager
General Help The general help provides basic information about the Laser Imager and its
functions.
1. On the Main Screen, touch the help button.
2. Select:
• a topic heading
• a specific topic
3. Touch View Topic.
Specific Screen Help This type of help provides information and/or instructions concerning the
screen on which the help button was touched.
Installation Road Map
The following sections provide a quick guide to the installation process.
There are two parts to the installation process: physical setup and
configuration.
Physical Setup This process includes:
• uncrating the Imager (see the uncrating instructions affixed to the crate)
• moving the Imager to its location (see Getting Started with the Kodak
DryView 6800 Laser Imager, 8F2901)
• installing film trays (see Getting Started with the Kodak DryView 6800
Laser Imager, 8F2901)
• connecting to the network (see Getting Started with the Kodak DryView
6800 Laser Imager, 8F2901)
• turning on power to the Imager (see Getting Started with the Kodak
DryView 6800 Laser Imager, 8F2901)
Configuration "Configuration" is the process of setting parameter values in the Laser Imager
to customize it to produce quality prints from images sent from the modalities
at this site.
Configure the Imager using the touch screen. From the Main Screen, touch
Utilities>Configuration>Installation Assistant.
You can exit the Installation Assistant any time and return to it later.
The following list outlines the basic configuration process.
• Select your language
• Select a service phone number
• Set up the date and time
– Select your time zone
To Next Page
Loading...
